1-phase power network meter N30P

N30P meter is destined to measure: AC voltage, AC current, active, reactive and apparent power, cos φ, tg φ, φ, frequency in single-phase power network.


  • Current: 0…1 or 0…5A
  • Voltage: 0…100V or 0…400V


  • Relay (4), analog (1), energy pulse (1), digital RS485/MODBUS (1)
  • 3-colour display – red, green and orange programmable in three intervals of the measured value
  • 14mm digit hight
  • Highlighted measuring units
  • 4 alarm outputs with signalling by LED diodes, Operating in 6 different modes
  • Conversion of any measured value into a 0/4…20mA or 0…10V analog signal
  • Storage of minimal and maximal values for all measured quantities
  • Meter programming from the keyboard or through the RS485 interface by means of free eCon software

Parameters can be reprogrammed are as follows:

  • Display colour, individually in three intervals
  • Thresholds of displayed overflows
  • Display precision of the result (decimal point)
  • Highlight of the unit
  • Average time of the measurement
  • Recounting of indications (individual characteristic
  • Power supply: 85…253V AC/DC or 20…40V AC/DC
  • Protection level from frontal side: IP65
  • External dimensions: 96 x 48 x 64 mm